Checking The Foot Shift Switch; Checking The Grip Warmers - Yamaha 2006 FJR1300AS Service Manual

Resistance
4.0–6.0 kΩ
M MMM M MMM M M MMM M
a. Connect the pocket tester (Ω × 1k) to the gear
position sensor terminals as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
• Positive tester probe →
blue "1"
• Negative tester probe →
black/blue "2"
1
L Y B/L
b. Measure the gear position sensor maximum
resistance.
L LLL L LLL L L LLL L
3. Install:
• Gear position sensor
Refer to "INSTALLING THE GEAR POSI-
TION SENSOR" on page 49.
ET2D21023

CHECKING THE FOOT SHIFT SWITCH

1. Remove:
• Foot shift switch
2. Check:
• Foot shift switch maximum resistance
Out of specification → Replace the foot shift
switch.
Resistance
4.0–6.0 kΩ
M MMM M MMM M M MMM M
a. Connect the pocket tester (Ω × 1k) to the foot
shift switch terminals as shown.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
M MMM M M MMM M M MMM M
2
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
ELECTRICAL COMPONENTS
• Positive tester probe →
blue "1"
• Negative tester probe →
black/blue "2"
MMM
b. Measure the foot shift switch maximum resis-
tance.
L LLL L LLL L
3. Install:
• Foot shift switch
Refer to "INSTALLING THE FOOT SHIFT
SWITCH" on page 59.
ET2D21024

CHECKING THE GRIP WARMERS

The following procedure applies to both of the
grip warmers.
1. Check:
• Grip warmer resistance
Out of specification → Replace the grip
LLL
warmer.
M MMM M MMM M
a. Disconnect the grip warmer coupler from the
front cowling wire harness.
b. Connect the pocket tester (Ω × 1) to the grip
warmer coupler as shown.
• Positive tester probe →
black "1"
MMM
• Negative tester probe →
black "2"
– 133 –
2 1
B O L
L LLL L L LLL L L LLL L
Grip warmer resistance
1.21–1.48 Ω at 20 °C (68 °F)
M MMM M M MMM M M MMM M
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
L LLL L LLL
M MMM M MMM