Yamaha 2006 FJR1300AS Service Manual page 127

Fault code No. Sh_ _45
Order Item/components and probable
cause
1 Shift rod
2 Defective shift actuator.
3 Confirm the operation of the main
switch after repairing the malfunction
or correcting the cause.
NOTE:
If the main switch is turned to "OFF", the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to "ON". Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
Fault code No. Sh_ _46
Order Item/components and probable
cause
1 Gear position setting.
NOTE:
If the main switch is turned to "OFF", the fault code number will disappear from the display and will not
be displayed again when the main switch is turned back to "ON". Therefore, use the engine stop switch
to stop the engine, not the main switch. If the fault code number has disappeared, activate the diagnos-
tic mode and select diagnostic code No. Sh_ _61. The fault code numbers can be confirmed in the mal-
function history.
YCC-S (Yamaha Chip Controlled-Shift) SYSTEM
Symptom
Symptom
– 118 –
Shift operation and gear position do not match.
Check or maintenance job
• Check the shift rod pin hole lo-
cation.
• Check the shift rod groove loca-
tion.
• Adjust or replace if defective.
Refer to "CHECKING THE
SHIFT ROD" on page 59 and
"INSTALLING THE SHIFT AC-
TUATOR" on page 61.
• Replace shift actuator.
• Execute the diagnostic mode.
(Code No. Sh_ _64)
Engine speed and gear position sensor signal
do not match while vehicle is driven.
Check or maintenance job
• Execute the diagnostic mode.
(Code No. Sh_ _65)
Reinstatement
method
Turning the
main switch to
"OFF".
See NOTE.
Reinstatement
method
Turning the
main switch to
"OFF".
See NOTE.