Table of Contents
Advertisement
STB-2000 Cabling Connections (Cont.)
(Continued from previous page)
While the STB is turning ON and sending the turn ON command to the display, the STB LED blinks at
a constant rate. Once both the STB and the display panel are ON, the STB LED remains lit but blinks
off twice in rapid succession every five seconds. The first image you should see on the display panel is
the Setting a Resolution screen from the STB (see "Setting the Video Output Resolution" on page 14).
4. Select the video output resolution (i.e, the STB's video output format), and complete the appropriate
Commercial Mode setup procedures, as described in this document.
Note: It is recommended that you complete STB-2000 Commercial Mode setup procedures before you
make external equipment connections to the STB-2000.
STB-2000 Cabling Diagram
See also step 2 of procedure above.
a) Connect DISPLAY
CONTROL 2 to LG Hospitality
display panel MPI port or to
commercial non-LG TV MTI
(DATA) port. *
b) Connect HDMI OUT
on STB to HDMI IN on
display panel. **
*
Only one DISPLAY CONTROL connection
should be used, depending on the type of
display panel to be controlled.
**
The STB default configuration automatically
sends Display Control commands to switch the
connected display panel to its HDMI1 input.
8
STB-2000 Front Panel
DISPLAY
MPI
CONTROL 2
LAN
DIGITAL
OUT
AUDIO
STB-2000 Rear Panel
IN 2
IN 1
USB IN 2
USB IN 1
POWER
AUDIO
DISPLAY
AV IN
SERVICE
IR IN
LINE OUT
CONTROL 1
a) Connect DISPLAY
CONTROL 1 to LG Public
Display or Commercial Monitor
display panel RS-232 port. *
ANTENNA/
CABLE IN
c) & d) Complete STB Power
and Antenna/Cable connections.
206-4256
Advertisement
Table of Contents
