LG STB-2000 Setup Manual page 22

EZ-Manager Wizard (Cont.)
The procedure below assumes that the desired file(s) is/are already loaded onto the USB device.
For further information on USB Download Menu functions and file requirements, and/or for
information on creating configuration files, refer to the appropriate section(s) in this document.
Before You Begin
• If you intend to use the Zoning feature(s) on this STB, make sure to assign the appropriate TV
Zone # and/or Wi-Fi Zone # in the EZ-Manager's Zones, Label, and Room Number screen
BEFORE continuing with USB Configuration. See "TV Configuration Options" on page 17 for
further information.
• Ensure the USB device to be used has been formatted with FAT format.
• Refer to "Custom Master STB Setup" on pages 35 to 38 for information on creating a TLX or TLL
file for cloning purposes, and/or refer to "Creating an FTG Configuration File" on pages 45 to 46
for information on creating an FTG Configuration (.tlx) file for FTG Mode configuration.
• See Reference section, "Upgrading TV/PTC Software using a USB Memory Device," for further
information on software upgrades.
USB Configuration via EZ-Manager Wizard
With either the TV Configuration Options or the Zones, Label, and Room Number screen on display,
proceed as follows to configure the STB/display using the USB memory device.
1. Insert the USB memory device that contains the appropriate file(s) into either of the STB's USB
ports.
2. Use the arrow keys on the Installer Remote to select USB Configuration, and then press OK.
You will be redirected to the TV's USB Download Menu:
USB Download Menu
Upgrade STB Software
Upgrade PTC Software
Diagnostics
Teach To STB (TLL)
Teach To STB (TLX)
Previous
Note: You can press
3. Select the appropriate option from the USB Download Menu, and complete the download as
required.
Note: If you perform a software upgrade from the USB Download Menu, the STB will complete
the upgrade and then reboot. Upon restart, the EZ-Manager TV Configuration Options screen will
be displayed on the screen. If desired, you can re-access the USB Download Menu (to perform
additional functions), proceed with configuration via the wizard, or exit the wizard.
4. Remove the USB memory device, and verify that the appropriate configuration is resident on
the STB.
22
OK
on the Installer Remote at any time to return to the EZ-Manager Wizard.
206-4256