Samsung OfficeServ 7100 Technical Manual page 323

OfficeServ 7100
TECHNICAL MANUAL
10. CALLER ID† DATA
11. ABANDON CALL†
12. NO. OF DIAL MASK
13. INCOMING ANSWER If this option is set to YES, the duration of calls ringing
14. INTERCOM CALL
15. KEY MMC IN/OUT
16. HOTEL CALL COST This option determines if the cost of the Hotel Room will
17. HOTEL PAGE FEED This option determines at which point, the printer will
18. HOTEL START LINE This option determines the point at which the system will
19. ITP REGISTRATION: When set to YES, whenever an ITP set registers with the
19. SET RELOCATION:
MMC: 725
This option can be selected to print Caller ID data
received from the Central Office on incoming calls. This
option requires the use of a 132 column (wide carriage)
printer or an 80 column printer set for condensed print.
If this option is set to YES, unanswered calls for which CID
information was received will print on SMDR.
If this option is set to a numeric value, the selected last
digits of the number dialed field will be masked as
asterisks (*) on the SMDR print out. Maximum masked
digits is 18.
before answered will print on SMDR.
If set to YES intercom calls will print on SMDR.
If set to YES then the SMDR record will show
programming being opened and closed in MMC 200 and
MMC 800.
be presented on the SMDR printout (NOT USED IN USA).
perform the page feed function (NOT USED IN USA).
begin counting, to determine which line to begin printing
reports (NOT USED IN USA).
system the SMDR record will show the station number in
the EXT field and the IP address and signalling port in the
ACCOUNT field.
When set to YES the SMDR record will print set relocation
activity. One station number will print in the EXT field and
the other station number will print in the ACCOUNT field.
Table of Contents
Home Page
PROGRAMMING
PART 2 APRIL 2007