Panasonic KX-UDS124 Installation Manual page 74

4 Deployment Procedure
•
SIP-CSs with a signal strength that is sufficiently strong but that are not currently connected are also
displayed in green on the S-PS's LCD screen.
•
When the S-PS moves towards another SIP-CS, the RSSI level of the currently connected SIP-CS
changes.
•
Handover is performed when the RSSI level of the currently connected SIP-CS becomes lower than the
other SIP-CS's RSSI level.
•
Make sure to check that there is no noise during handover.
Exiting S-PS Area Check Mode
When the S-PS area check is finished, exit the S-PS area check mode.
1.
Start the S-PS in Maintenance mode.
For details, see "Starting the S-PS in Maintenance Mode" in "4.3 Site Survey".
2.
Select "PS area check", and then press
3.
Select "Off".
4.
Press .
5.
Press the POWER key until the S-PS is turned off.
6.
Press the POWER key until the S-PS is turned on.
7.
Repeat the procedure from 1 to 6 for the other S-PS.
74 Installation Guide
.