Panasonic KX-UDS124 Installation Manual page 47

Registering SIP-CSs to the Air Sync Master CS (Air Sync Group 1)
1.
In the System tab, select CS Management.
2.
Select the number of SIP-CSs to register newly from the Number of CS pull-down menu.
3.
Click Start CS Registration.
4.
Click OK.
All the SIP-CSs on the LAN will be registered, and then displayed in CS Registered List.
Note
•
After clicking Start CS Registration, when the number of registered SIP-CSs reaches the number
specified in Number of CS, "Complete" is displayed and registration stops automatically.
•
Click Stop CS Registration to quit registration.
•
If you want to register all SIP-CSs in step 2, select the maximum number of SIP-CSs. In this case, after
the detected SIP-CSs have been registered, wait 5 minutes for the timeout display or click Stop CS
Registration.
•
After registration, check the CS Registered List to confirm that the SIP-CSs have been registered.
Notice
You cannot register the following SIP-CSs:
•
SIP-CSs that are not turned on
•
SIP-CSs that are not connected to the network
•
SIP-CSs for which no IP address has been set
•
SIP-CSs that cannot receive radio signals from the Air Sync Master CS
Registering SIP-CSs to the Air Sync Master CS (Air Sync Groups 2–8)
1.
In the System tab, select CS Management.
2.
Select an Air Sync Group.
3.
Select the number of SIP-CSs to register from the Number of CS pull-down menu.
4.
Click Start CS Registration.
5.
Click OK.
Note
•
At first, the CS Registered List for Air Sync Groups 2–8 is blank.
4 Deployment Procedure
Installation Guide 47