installation & connection
ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the network encoder.
Be careful not to reverse the polarity when you connect the power cable.
J
You can also use a router featuring PoE (Power over Ethernet) to supply power to the network
encoder.
1_ installation & connection
SD CARD
SD
POWER
-
+
DC 12V
Power
ETHERNET/ PoE
RESET
D+D-S1 G NC CM NO
RS-485 SENSOR RELAY OUT
Ethernet