D-Link DIR-868L User Manual page 65

Section 3 - Coniguration
Static IPv6 Address Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does not change. The IPv6 information is manually entered in your
IPv6 coniguration settings. You must enter the IPv6 address, Subnet Preix Length, Default Gateway, Primary DNS Server, and Secondary DNS
Server. Your ISP provides you with all this information.
Use Link-Local The Link-local address is used by nodes and routers when
Address: communicating with neighboring nodes on the same link. This
mode enables IPv6-capable devices to communicate with each
other on the LAN side.
IPv6 Address: Enter the WAN IPv6 address for the router here.
Subnet Preix Enter the WAN subnet preix length value used here.
Length:
Default Gateway:
Enter the WAN default gateway IPv6 address used here.
Primary DNS
Enter the WAN primary DNS Server address used here.
Address:
Secondary DNS Enter the WAN secondary DNS Server address used here.
Address:
LAN IPv6 Address:
These are the settings of the LAN (Local Area Network) IPv6 interface for the router. The router's LAN IPv6 Address coniguration is
based on the IPv6 Address and Subnet assigned by your ISP. (A subnet with preix /64 is supported in LAN.)
D-Link DIR-868L User Manual 61