Panasonic WV-SW390 Series Operating Instructions Manual page 15

Audio output button
Turns on/off the audio transmission (play audio from the PC on the unit speaker). This button will be
displayed only when "Audio output", "Interactive(Full-duplex)" or "Interactive(Half-duplex)" is selected for
"Audio transmission/reception" on the setup menu. (®page 124)
The button will blink during the audio transmission.
When this button is clicked, the button will turn into the
Audio output volume can be adjusted (Low/Middle/High) by moving the volume cursor
Note
•
When a user is using the audio transmission function with "Interactive(Half-duplex)" selected, the
receiver button and the transmission button will be inoperable for the other users. When
"Interactive(Full-duplex)" is selected, the transmission button is inoperable for other users.
•
Possible duration of audio transmission is up to 5 minutes per transmission. When 5 minutes have
passed, the audio transmission will automatically stop. To turn the audio transmission function on,
click the [Audio output] button again.
•
When the camera is restarted, the adjusted volume level (for both the audio transmission and
reception) will return to the level that had been set on the [Audio] tab on the setup menu.
(®page 124)
•
Actual volume level will change in three steps even though the volume cursor can be adjusted
minutely.
SD recording status indicator
The status of the SD recording can be checked with this indicator.
When the SD recording starts, the SD recording status indicator will light red. It will go off when the SD
recording stops.
This indicator will be displayed when "Manual" or "Schedule" is selected for "Save trigger" on the setup
menu. (®page 54)
Main area
*4
Images from the camera will be displayed in this area.
The current time and date will be displayed according to the settings configured for "Time display format"
and "Date/time display format". (®page 50)
In addition, when being adjusted, the status of brightness (®page 51), panning/tilting degree and the
zoom ratio display (®page 92), camera position (®page 92), and the preset ID (®page 110) will be
displayed as well as the characters configured for "Camera title on screen" (®page 51). The number of
lines for the display is 3 when using WV-SW396/WV-SW395/WV-SC386/WV-SC385, 2 when using
WV-SC384.
Click a desired point in the main area on the "Live" page that is to be the center of the angle of view. The
camera moves to adjust the position in order to set the clicked point as the center.
When selecting an area in the main area by dragging the mouse, the selected area will be located at the
center of the main area. In this case, the zoom ratio will be adjusted automatically.
Zoom can be adjusted using the mouse wheel.
:
SW396 SC386
When the main area of the "Live" page is right-clicked, "Auto track" starts for the clicked object. Depending
on the targeted object or its surroundings, "Auto track" may not perform normally.
Note
•
When operated by a lower access level user, images displayed on the screen may be changed
temporarily. This does not affect operation of the camera.
•
When the displayed image is being zoomed in more than 18x
SW396 SC386
•
When the mouse is dragged to move the camera beyond its operable range, the camera will move to
the requested direction and will stop at the end of the operable range. Then, the zoom ratio of the
displayed image will automatically be adjusted.
*5
, the clicked point may not always be located at the center of the main area.
1 Monitor images on a PC
button and audio from the PC will not be heard.
SW395 SC385
Operating Instructions
.
/36x
SC384
15