Reconnecting your SmartBand using NFC
If your SmartBand loses connection, for example, when the connected Android™
device goes out of range, you can reconnect the two devices using NFC.
To reconnect your SmartBand using NFC
1
Android™ device: Make sure that the NFC function is turned on and that the
screen is active and unlocked.
2
Place the Android™ device over your SmartBand so that the NFC detection
area of each device touches the other.
SmartBand is connected.
Day mode and night mode
Your SmartBand has two primary modes: day mode and night mode. Each mode is
indicated by different notification light patterns. In day mode, your SmartBand
vibrates to notify you of alarms and incoming messages and calls. And it logs data
about your activities, such as steps you've taken and hours you've walked or run. In
night mode, the SmartBand logs your sleep and can wake you up if you've set an
alarm. All other functions are turned off.
Mode
Notification light pattern
Day mode
Notification lights illuminate one by one, then all lights go out.
Night mode
The notification lights alternate between one lit and two lit lights.
To check the mode of your SmartBand
•
Briefly press the power key. The notification lights blink according to the light
pattern for day or night mode.
To switch between day mode and night mode
•
Press and hold down the power key for two seconds.
Resetting your SmartBand
Reset your SmartBand if it behaves unexpectedly or if you want to connect it to a
new device.
To reset your SmartBand
1
Turn off your SmartBand.
2
Press and hold down the power key until notification light A starts flashing.
This is an Internet version of this publication. © Print only for private use.
appears in the status bar when the
7