Setting Up Your Smartband; Preparing To Use Your Smartband - Sony SmartBand SWR10 User Manual

Setting up your SmartBand

Preparing to use your SmartBand

For your SmartBand to work, it must be connected to your Android™ device and the
latest versions of the following applications must be installed on the Android™
device: Smart Connect, SmartBand and Lifelog.
If you set up your SmartBand using NFC, you are guided during setup to Google
Play™, from where you can install the necessary applications to use with your
SmartBand.
If you set up your SmartBand using Bluetooth®, you have to go through some extra
steps to install the necessary applications from Google Play™ and connect to your
Android™ device.
The Smart Connect application is pre-installed on all Android™ devices from Sony Mobile at
purchase. Make sure that you update it to the latest version.
After the SmartBand application is installed, it is not located on the Application screen. You
can access it under Devices in the Smart Connect application after your SmartBand is
connected to the Android™ device.
To set up your SmartBand using NFC
1
Make sure that your SmartBand is charged for at least 30 minutes.
2
Android™ device: Make sure you have installed or updated the Smart Connect
application to the latest version from Google Play™.
3
Android™ device: Make sure that the NFC function is turned on and that the
screen is active and unlocked.
4
Place the Android™ device over your SmartBand so that the NFC area of each
device touches the other, then follow the instructions on the Android™ device
to install the SmartBand application and the Lifelog application.
the status bar when the SmartBand is connected.
If you touch the NFC areas of each device to each other after all applications are installed and
your SmartBand is on and connected, the Lifelog application starts automatically.
To set up your SmartBand using Bluetooth®
1
Make sure that your SmartBand has been charged for at least 30 minutes.
2
Android™ device: Make sure you have installed or updated the Smart Connect
application to the latest version from Google Play™.
3
Turn on your SmartBand.
4
Android™ device: Turn on the Bluetooth® function, then scan for Bluetooth®
devices and select SWR10 in the list of available devices.
5
Start the Smart Connect application.
6
Follow the instructions to install the SmartBand application and the Lifelog
application. appears in the status bar when the SmartBand is connected.
All applications required for the SmartBand to work are available on Google Play™.
This is an Internet version of this publication. © Print only for private use.
6
appears in