Sharp AM-900 Service Manual page 27

3. Print diagnosis
3.1. Single print
In this mode, a sheet with selected pattern is printed.
Printing size depends on Paper Size setting in Common Setting.
SINGLE PRINT 2: ALL WHITE
[>]Key
[ENTER]Key
1: CHECK PATTERN
[>]Key
11: IDBG CHART
[>]Key
10: SG CHRAT
[>]Key
9: 5% CHART
8: GENERAL CHART
[>]Key
Select the desired pattern with the [>] key and [<] key and press the
[ENTER] key.
1: Check Pattern : same as Figure 1
2: All White pattern : Not printed
3: All Black pattern : Printed with black within print area
4: Area pattern : Frame line is printed within print area
5: Stripe pattern : Lateral stripe (Black 2 lines and White 2 lines)
6: Halftone pattern : same as Figure 3
7: Phil chart : PHIL CHART pattern
8: General chart
9: 5 % chart
10: SG chart
11: IDBG chart
(a) Area pattern
It prints 30 mm long per a pattern.
1: Full Black pattern
2: Halftone 2 pattern (The Figure 2 is repeated.)
3: Halftone 1 pattern (The Figure 3 is repeated.)
4: Mesh point pattern (The Figure 4 is repeated.)
5: Longitudinal stripe (Black 2 dots and White 2 dots are repeated in
2 pattern the line.)
6: Lateral stripe (Black 2 lines and White 2 lines are repeated.)
2 pattern
7: Lateral stripe (Black 1 line and White 1 line are repeated.)
1 pattern
8: Full White pattern
9: Full Black pattern
3: ALL BLACK
[>]Key
[>]Key
4: AREA PATTERN
[>]Key
5: STRIPE PATTERN
[>]Key
6: H-TONEPATTERN
[>]Key
7: PHIL CHART
[>]Key
2 – 11
1
2
3
4
5
6
7
8
9
Figure 1 Check Pattern
Figure 2 Halftone 2 Pattern
Figure 3 Halftone 1 Pattern
Figure 4 Mesh point Pattern
AM-900U