Bluetooth Friendly Name; Discoverable Mode - Motorola LI4278 Product Reference Manual

4 - 6 LI4278 Product Reference Guide

Bluetooth Friendly Name

You can set a meaningful name for the linear imager scanner that appears in the application during device
discovery. The default name is the linear imager scanner name followed by its serial number, e.g.,
123456789ABCDEF
to maintain the user-programmed name through a Set Defaults operation.
To set a new Bluetooth Friendly Name, scan the following bar code, then scan up to 23 characters from
Appendix E, ALPHANUMERIC BAR
Message on page E-7
NOTE If your application allows you to set a device name, this takes precedence over the Bluetooth Friendly
Name.

Discoverable Mode

Select a discoverable mode based on the device initiating discovery:
•
Select General Discoverable Mode when initiating connection from a PC.
•
Select Limited Discoverable Mode when initiating connection from a mobile device (e.g., Motorola Q),
and the device does not appear in General Discoverable Mode. Note that it can take longer to discover
the device in this mode.
The device remains in Limited Discoverable Mode for 30 seconds, and green LEDs flash while in this
mode. It is then non-discoverable. To re-active Limited Discoverable Mode, press the trigger.
*
General Discoverable Mode
. Scanning Set Defaults reverts the linear imager scanner to this name; use custom defaults
CODES. If the name contains less than 23 characters, scan
after entering the name.
Bluetooth Friendly Name
Limited Discoverable Mode
LI4278
End of