Table of Contents
Advertisement
NEI-30 | VEI-30 Dinion Infrared Imager
1.
2.
3.
4.
5.
6.
7.
8.
NOTICE!
The camera has not been evaluated for safety requirements using other mounting kits.
2.2
Route Wires and Attach Connectors
Power wires must be routed to the right (front) side of the junction box through a separate
conduit. All video, control, and alarm wires must be routed through a second conduit to the
left side of the box.
WARNING!
External interconnecting cables are to be installed in accordance with NEC, ANSI/NFPA70 (for
US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in
accordance with local country codes for all other countries.
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Locate a stud in the wall and mark the outside edges of the stud.
Using the wall mount bracket as a template, align the mounting hole with the center of
the stud.
Mark the point on the wall in the center of the hole where the mounting bolt will be
positioned.
Remove the wall mount bracket and drill a pilot hole at the marked point.
Align the wall mount bracket mounting hole with the hole drilled in the wall.
Using a 9/16 in. (14 mm) socket and driver, secure the wall mount bracket by screwing
the 1/4-9 x 2 (M7-0.35 x 50) lag bolt with 1/2 in. (12 mm) washer securely into the stud.
Follow this procedure to attach the three remaining lag bolts.
Attach 3/4 in. (20 mm) NPS watertight pipe fittings (not supplied) to the bottom or back
holes of the junction box through which you will run the power, video, and control data
wires.
Route all video, control, and alarm wires through the conduit fitting on the left side of the
junction box. See Section 3 Connection, page 9 for coax, UTP, and fiber optic
specifications and distances.
Route the 24 VAC / 12 VDC lines through the conduit fitting on the right side of the box.
Cut and trim all wires with sufficient slack to reach their connector terminals in the box,
but not so long as to be pinched. See Figure 2.2, Page 8, above, for the connector
locations.
Attach the supplied 2-pin Power Plug to the incoming power wires.
Attach the supplied 7-pin relay output plug to the incoming relay wires.
Attach a BNC connector to the incoming video coax cable. If using UTP for video or
installing an Ethernet model, attach an RJ45 plug to the incoming UTP cable. If installing
a Fiber Optic model, attach an ST fiber plug to the fiber optic cable. See
Section 3 Connection, page 9, for the different methods of transmitting video and for wire
specifications.
Quick Install Guide
Installation | en
7
F.01U.166.250 | 1.0 | 2011.04
Advertisement
Table of Contents
