GE MDS entraNET 900 Technical Manual page 126

STATS
STATTRACKER
116
: Shutdown mode is enabled. In this mode, the radio
SHUTDOWN
draws less than 1 mA at a supply voltage of 12 Vdc. Note that
this mode requires a longer wake-up time, almost as long as if
the radio was de-powered.
This command is used to place the radio into immediate
NOW=<setting>—
Sleep or Shutdown mode.
: The radio immediately enters Sleep mode.
Sleep
: The radio immediately shuts down, drawing less than
Shutdown
1 mA at a supply voltage of 12 Vdc.
—Selects a control option to activate (enter) or
WAKE=<dtr, data>
deactivate (exit) Sleep or Shutdown modes.
: Wake under DTR signal control.
DTR
: Wake up on data.
DATA
Displays radio statistics. If
all statistics are displayed.
Optional arguments:
: Displays all statistics.
ALL
: Displays radio packet statistics.
RADIO
: Displays
COM1
COM1
:Displays
COM2
COM2
: Displays Ethernet packet statistics.
ETH
: Resets packet statistics for the indicated interface.
RESET
When the
STATTRACKER
sends UDP packets with a broadcast destination IP address. The
command has a user-defined port number between 30000 and 60000,
and sends packets consisting of:
• RSSI statistics
• Connectivity
• Packets received
• Packets transmitted
• Packets dropped
• Bytes received
• Bytes transmitted
The source MAC address in the UDP packet is the MAC address from
the entraNET AP. These monitoring packets are sent every time there is
over-the-air traffic.
This command is designed to work with the GE MDS Mobility
Application available from GE MDS (Part No. 06-4157A01).
MDS entraNET Technical Manual
(
<device> RADIO, COM1, COM2, ETH
packet statistics.
packet statistics.
mode is turned on, the Remote transceiver
• Receive byte errors
• Transmit byte errors
• Total fragments
• Total retries
) is omitted,
05-4055A01, Rev. E