Speaker Setup (Detailed Setup); Speaker Setup Flow; Speaker Configuration - Kenwood KRF-V6400D Instruction Manual

Speaker setup (Detailed Setup)

The detailed settings allow you to enjoy full performance of the
receiver according to the environment of your listening room.
For creating the best listening environment, Kenwood
recommends to perform the setup at the listening position.
SETUP
MULTI CONTROL
/

Speaker setup flow

Speaker setup flow
Speaker settings consist of 6 elements.
1
Enter the Detailed Setup mode.
[SETUP]
Use [MULTI CONTROL ∞/5] to select an item to set.
[SETUP]
Elements Display

Speaker Configuration

"SP SETUP"
Speaker Level "TESTTONE"
Speaker Distance "DISTANCE"
Crossover "CROSSOVER"
Low Frequency Effects
"LFE LVL"
Level
Lip Sync
"LIP SYNC"
(KRF-V6400D only)
"EXIT"
2
Set each item.
See the followings for each setup item.
Setting
Selects whether each speaker channel is
used or, if used, its size.
Selects the output level from each
speaker.
Selects the distance between each
speaker and the listening position.
Sets the lower limit of the bass
frequencies reproduced from the speakers
set to "NML" in the "SP SETUP". The
frequencies below the frequency set here
are distributed to other speakers (those
set to "LRG" and the subwoofer).
Selects the level of bass audio
enhancement.
Low Frequency Effect channel delivers
separate non-directional bass signals to
the subwoofer for more dynamic deep
bass sound effects.
Adjusts the deviation in time between
the video and audio.
Exits the Detailed Setup mode.
Speaker configuration Speaker configuration
Select the use of each speaker and its size.
1
Enter the Detailed Setup mode.
[SETUP]
Use [MULTI CONTROL ∞/5] to select "SP SETUP".
[SETUP]
2
Select the use and size of each speaker.
Use [MULTI CONTROL ∞/5] to select the speaker and its
use or size.
[SETUP]
Repeat the above operations until all of the speakers
have been set up.
Speaker Display
"SUBW ON"
Subwoofer
"SUBW OFF"
"FRNT LRG"
Front speaker
"FRNT NML"
"CNTR LRG"
Center speaker "CNTR NML"
"CNTR OFF"
"SURR LRG"
Surround speaker "SURR NML"
"SURR OFF"
"BS LRG"
Surround Back speaker
(KRF-V6400D only) "BS NML"
"BS OFF"
"RMX ON"
Subwoofer Re-mix* 1
"RMX OFF"
* 1 Mixes the bass tone of other channels to the subwoofer
channel.
3
Go to the next setting.
Setting
Subwoofer is connected.
Subwoofer is not connected.
Large size front speaker
Average size front speaker
Large size center speaker
Average size center speaker
Center speaker is not connected.
Large size surround speaker
Average size surround speaker
Surround speakers are not connected.
Large size surround back speaker is
connected. (6.1ch)
Average size surround back speaker is
connected. (6.1ch)
Surround back speaker is not connected.
Subwoofer re-mix is on.
Subwoofer re-mix is off.
Continued
23
English