Initial Installation - Philips FaxJet 520 User Manual

Only insert the cartridge if the device is connect-
ed to the electricity power supply. Otherwise, the
cartridge will not be detected.
5 Press the cartridge down until it snaps into place.
6 Close the device by folding the document holder down
and swivelling the metal bracket upward.
7 Then close the control panel.
Installation guide

Initial installation

After you connect your device to the mains voltage, the in-
itial installation commences.
Subsequent initial installation
You can start the initial installation at a later point of
time using MENU and 1 also
Printing the menu overview
You can print the menu overview using MENU and
2.
Selecting the language
1 Use [ to select the desired display language.
2 Confirm with o.
Selecting the country
Setting the Country Correctly
Always set the country in which you are operating
the machine. Otherwise, your machine is not adapt-
ed to the telephone network. If your country is not
included in the list, you must select a different setting
and use the correct telephone cable for the country.
Consult your retailer.
Setting the country
1 Use [ to select the country in which you are operat-
ing the device.
2 Confirm with o.
Activating the printing head
1 Confirm NEW PRINT CART.? using 1 to set the
ink level memory to "full".
2 A test page is printed.
3 Check the print sample for interruptions.
4 If necessary, repeat the printing using 0.
5 You can finish using 1 and j.
Entering the date and time
1 Press MENU. RECEPT. SET-UP appears on the
display.
2 Select using [ FAX SET-UP .
3 Confirm with o.
4 Confirm DATE AND TIME with o.
5 Select using [ SET DATE/TIME .
6 Confirm with o.
7 Enter the date (two digits each) e.g. 080608
for 08.06.08.
8 Enter the time, e.g. 1400 for 2 pm.
9 Confirm with o.
10 You can exit with j.
Select further settings in step 5 using [
DATE FORMAT - Change the date format
HOUR FORMAT Change the time format (12/24
clock).
Note: power failure ljet 3
If SET DATE/TIME appears in the display, you
must adjust the date and time.
1 Press MENU and confirm using o.
2 Enter the date and time with the numeric keys.
3 Confirm with o.
EN
5