Product Dimensions - GE ZVC36LSS Installation Instructions Manual

Design Information
PRODUCT DIMENSIONS
ZVC30 Dimensions and Specifications (in inches)
Outside Dimensions
27-1/2_
The custom canopg must be sized to fit the insert
sleeve. Construct the canopg with an opening
that is:
26"W x 13-3116"D
The opening must be constructed of 3/4" thick
material to allow the sleeve locking clips to
engage.
The Supplied Liner
28-1/2"
21-1/4"
The stainless steel liner is shipped with each hood
insert. This non-combustible liner protects the
underside of the canopg,
Custom Liner
If gou are not using the supplied liner, gou mug
construct a custom non-combustible liner. Use the
supplied liner as a template. The opening must be
26'MI x 13-3116"D. 3/4" thick material must
surround the opening to allow the sleeve locking
clips to engage. The insert sleeve inside the cabinet
should be positioned 1/2" from the rear wall so
that the center of the 8" duct is 5-1/2" from the
rear wall.
'2"
The Insert Sleeve
251:,
1/2"
The bottom edge of the insert sleeve has a 7/8"
wide flange on the sides and a 1/2" wide flange
on the front and back.
Remote Location for the Control
The control may be removed from the hood
and installed into a wall or countertop, A 30-ft.
length of wire is supplied to accommodate most
installations. A blanking plate covers the opening
when the controls are removed.
The overall size of the control is 4-114" wide and
2-1/4" deep.
4
1-11116"
3-11/16"
Control cutout
1/2"
We recommend that the cutout in granite or other
hard surfaces be made before the countertop is
installed.