Step 5, Install Blower Motor; Step 6, Connect Wiring Harness - GE ZVC36LSS Installation Instructions Manual

Installation Instructions
ISTEP sl
INSTALL BLOWER MOTOR
iioooooii
1. Pick up blower motor and rotate so tabs align
with damper plate bracket.
2. Insert blower motor into insert sleeve through
cutout opening of custom cabinet frame.
3. Place blower motor on damper plate assemblg
bg sliding blower motor tabs into slots of damper
plate assemblg.
00000
4. While holding blower motor in place, lift right side
so that blower motor bolt holes align with bolts
protruding from damper plate assemblg and
secure with lock washers and wing nuts (hand
tighten).
ISTEP 6 1CONNECTWIRING HARNESS
NOTE:On ZVC48,there are three routing clips and two wiring harnessesto connect.
Wiring
harness o ooo o
®
1. Locate both ends of wiring harness. 3. CarefullL
2. Connect wiring harness bg inserting male into
female opening.
Brackets
route wiring harness and ground wire
through two clips attached to blower plate
assemblg.
2O