Setting The Jumpers On The Communication Board On The Relay Plus Unit - Bosch F.01U.252.722 User Manual

16 en | Installation
3.2.6

Setting the jumpers on the communication board on the Relay Plus Unit

1.
2.
3.
Setting the jumpers for a Display Zettler:
Setting the jumpers for a printer setup or a Display Norsk:
4.
F.01U.252.722 | V1 | 2011.12
Disassemble the unit; see Section 6.5.1 Disassembling the unit, page 29.
Remove the communication board; see Section Removing the communication board,
page 29.
Set the jumpers as required in your configuration. By default the jumpers are set for
connection to a Display Zettler.
Assemble the communication board and the unit. This is basically the reverse of the
disassembling procedure, see Section 6.5.1 Disassembling the unit, page 29.
User Manual
NurseCall Relay Unit
Bosch Security Systems