Bosch INTEGRUS Installation And Operating Manual page 46

| en INTEGRUS | Digital Infra-red Language Distribution System
46
The radiator (plus suspension bracket) is attached to the wall bracket by sliding the mounting bolt over the slot on the wall
bracket and then tightening it (see Figure 3.9). A split pin is then inserted into a small hole in the bolt to stop it from working
loose (see inset in Figure 3.9). The vertical angle of the radiator can be adjusted between 0 and 90° in steps of 15°. The
horizontal orientation of the radiator can be adjusted by loosening the bolt then turning the radiator to the required position.
Figure 3.8 Attaching the wall mounting bracket to a wall Figure 3.9 Attaching the radiator to the wall mounting bracket
Ceiling mounting
The radiators can be attached to the ceiling using the supplied suspension bracket. This ensures enough space for a proper air
flow around the radiator. Mounting a radiator in the ceiling will in most cases require a forced air flow by means of a ventilator
to prevent overheating.
Mounting on horizontal surfaces
When the radiator has to be positioned a horizontal surface (e.g. on top of an interpreter booth), the distance between the
radiator and the surface must be at least 4 cm (1.5 inch) to enable enough air flow around the radiator. This can be achieved by
using the suspension bracket as a support. If this is not possible, switch the radiator to half power. If the radiator is used at full
power on top of an interpreter booth, the ambient temperature must not exceed 35° C.
BOSCH Security Systems B.V.| February 2003