View Fault Status; Set Monitoring Options; View Version Information - Bosch INTEGRUS Installation And Operating Manual

INTEGRUS | Digital Infra-red Language Distribution System
2.5.4

View fault status

The fault status of the radiators can be seen in the second screen of the Main menu:
Menu Items
1 Fault Status
When the system detects a failure for the first time, a flashing fault message pops-up on any menu screen:
Radiator Fault
Push the menu button to remove the fault message from the screen and to go back to the menu screen that was visible before
the fault message popped-up. The flashing message will also disappear when the fault has been resolved.
2.5.5

Set monitoring options

The Monitoring sub-menu (2) is used to set which signal is sent to the monitoring headphone output. It can be one of the
inputs, one of the channels or no signal.
When the sensitivity of one of the inputs is being changed in the Setup menu (4I, 4J or 4K), or when assigning inputs to
channels (menu 4C, Per Channel), the monitoring output automatically switches temporarily to that source, even when the
option 'None' has been chosen.
When the headphone output is disabled (see section 2.5.17), the output level can not be changed and the level indicator is not
visible.
Menu Item Option
2A Source/Volume Source:
- In. nn
- Ch. nn
- Aux.L
- Aux.R
- None
The 'Source/volume' screen also displays level meters (two for a stereo source, one for a mono source) for a visual indication of
the actual signal strength: ▄ = low level, █ = high level, ▲ = overflow.
2.5.6

View version information

In the Enquiry sub-menu (3), version information of the transmitter can be found. This information should be mentioned in
service requests or failure reports.
Menu Item Value (read only)
3A Board Nr e.g. 19.1.000001
3B Board Version e.g. 01.00
3C Software Version e.g. 1.00.0001
Value (read only)
Fault:
- No Faults
- Radiator Fault
- No Radiators
No Radiators
or
Value 1
Input nr:
00 ... 31
Channel nr:
00 ... 31
Description
The connected radiators function without problems.
One of the connected radiators is not functioning properly.
No radiators are connected to the transmitter.
Value 2 Description
Volume: The signal from audio input nn is available on the
-31 ... 0 dB monitoring headphone output.
Volume: The signal on channel nn is available on the
-31 ... 0 dB monitoring headphone output.
Volume: The signal on the Aux. Left input is available on the
-31 ... 0 dB monitoring headphone output.
Volume: The signal on the Aux. Right input is available on the
-31 ... 0 dB monitoring headphone output.
Volume: The monitoring headphone output is switched off
-31 ... 0 dB during normal operation, but is active when the
sensitivity of one of the inputs is being changed.
Description
Shows the serial number of the transmitter board.
Shows the version number of the transmitter board.
Shows the version number of the configuration software.
BOSCH Security Systems | February 2003
en |
37