Arming And Disarming Another Partition; Programming Another Partition; Arming And Disarming Multiple Partitions At The Same Time - GE 4 Series User Manual

Note
Check with your installer to
identify which keychain
touchpads can arm/disarm
multiple partitions.
Concord 4 Series Security Systems
To jump partitions using an access code:
1. From any hardwired touchpad, press
Touchpads display, "ENTER PARTITION" or "ENTER CMD."
the desired partition number (1 - 6)
2. Press
The touchpad sounds one short beep if the jump was successful. One long beep means the
jump was not successful. Alphanumeric touchpads display the text in the newly entered parti-
tion.
3. Proceed to arm, disarm, or program as needed. The partition assignment reverts back if no
touchpad buttons are pressed for 10 seconds.
To jump partitions without using an access code:
1. From any hardwired touchpad, press
Touchpads display, "ENTER PARTITION" or "ENTER CMD."
the desired partition number (1 - 6)
2. Press
The touchpad sounds one short beep if the jump was successful. One long beep means the
jump was not successful. Alphanumeric touchpads display the text in the newly entered parti-
tion.
3. Proceed to arm, disarm, or program as needed. The partition assignment reverts back if no
touchpad buttons are pressed for 10 seconds.

Arming and Disarming Another Partition

Any access code that can jump to another partition can control that partition. Once in the other
partition, you must use a valid code for arming and disarming that partition.

Programming Another Partition

Only System Master and Partition Master codes can be used for programming. Only one partition
can be programmed at a time. When one partition is in the programming mode, touchpads in the
other partition are locked out from any programming activity. However, arming and disarming
can continue.
Some partition-specific settings share resources, such as access codes and time schedules. For
example, if Partition 1 uses Regular User numbers 00 through 20, Partition 2 will not be able to
see or use those user numbers. The first Regular User number available for Partition 2 would be
21.
The allocation of time schedules works in much the same manner. There are 16 schedules that
can be used by any partition, but as soon as Partition 1 attaches a schedule to any event, that
schedule cannot be used by another partition, and vice versa.

Arming and Disarming Multiple Partitions at the Same Time

Your system may be set up to let you simultaneously arm and disarm more than one partition.
This can be done from system touchpads or keychain touchpads assigned to the associated parti-
tions.
To arm multiple partitions at the same time from a touchpad:
1. Press 2 or 3 on any touchpad assigned to one of the partitions you want to arm. The display
shows "ENTER CODE".
2. Enter your Access Code. The display shows all the partitions that will be armed.
3. Press # to arm all displayed partitions.
Or,
Press the number of any partitions you don't want armed (the partition numbers disappear
from the display), then press #.
To disarm multiple partitions at the same time from a touchpad:
1. Press 1 on any touchpad assigned to the partitions you want to arm. The display shows
"ENTER CODE".
2. Enter your Access Code. The display shows all the partitions that will be disarmed.
8 CODE 6
+ + .
.
7 4
+ .
.
29