Minimum Standby Battery - Bosch Conettix D6600 Installation And Operation Manual

28 en | Power
11.5 V to 10.2 V
Below 10.2 V
Table 9.1: Battery Voltage Display
Device
D6600 (one D6640/ D6641/
D6645 Card)
Additional D6640/ D6641/
D6645 Cards
Additional D6650/D6655
Cards
D6672 COM1 Adapter
Total Standby Current:
Table 9.2: Calculating Standby Current for the D6600
The standby current required for the D6600 depends on the number of optional cards
installed in the receiver. Use the table above to calculate the D6600 standby current. The
standby current required by the D6100IPv6 is listed in the table below.
12 V Battery Standby
330 mA
Table 9.3: Standby Current for the D6100IPv6
Notice!
i
18 Ah batteries are required to meet 24-hour standby requirements.
9.4.1

Minimum Standby Battery

The table below shows the maximum standby current for common rechargeable battery
capacities at 4-hour, 8-hour, and 24-hour standby periods. If the standby current is larger than
the value listed, you must use the next larger capacity battery.
Rechargeable Battery
Capacity
7 Ah
8 Ah
18 Ah
Includes 20% battery de-rating storage factor
2012.11 | 08 | 4998122704
Battery Low
Battery Bad
Qty 12 V Battery Standby
Current
1 800 mA
210 mA x Qty (2
to 7)
300 mA x Qty (1
to 8)
10 mA (if
installed)
Maximum Standby Current (mA)
4 hr
1400
1600
3600
Installation and Operation Guide
Conettix Communications Receiver/
Battery Missing
UPS AC Standby Current
800 m 350 mA
A
35 mA x Qty (2
to 7)
50 mA x Qty (1
to 8)
2 mA (if
installed)
Total UPS
Current:
UPS AC Standby Current
250 mA
8 hr
700
800
1800
Gateway
350 mA
24 hr
230
265
600
Bosch Security Systems, Inc.