Installation; Installation Check List - Bosch Conettix D6600 Installation And Operation Manual

Conettix Communications Receiver/
Gateway
8

Installation

Notice!
i
Refer to the appropriate Installation Supplement included with your product for the specifics
of your particular installation.
8.1

Installation Check List

top and bottom of the enclosure. Also confirm that connections did not loosen during
shipment (D6600 only).
top and bottom of the enclosure. Also confirm that connections did not loosen during
shipment (D6600 only).
Installation, page 20).
you can quickly switch over to the replacement card (refer to Card Installation, page 20).
Notice!
i
You can install spare line terminator cards. Do not install spare line cards.
telephone line(s). Plug the other end of the modular telephone cord(s) into the telephone jack
on the appropriate line terminator card(s).
D6100IPv6.
outlet (standard AC outlet).
Notice!
i
Maintain a 6.5 mm (0.25 in) gap, or greater, between power limited and non-power limited
circuit wiring.
of the transformer.
Bosch Security Systems, Inc.
Check each receiver card to see that it is correctly positioned in the card guides at the
Check each receiver card to see that it is correctly positioned in the card guides at the
Ensure that the earth ground is connected and grounded through the AC inlet.
If you are installing additional line cards, install the terminator cards now (D6600 only).
After installing additional line terminator cards, install the line cards (refer to Card
Install the line terminator card(s) from your spares package(s). If there is a malfunction,
Connect four or six conductor telephone cord(s) to the RJ11C jack(s) of the desired
Connect the supplied AC transformer wiring leads to the AC terminals on the rear of the
Plug the AC cord (D6600 only) into a correctly wired 120 VAC, 60 Hz or 220 VAC, 50 Hz
Plug the AC transformer into the correctly wired wall receptacle that matches the voltage
Installation and Operation Guide
Installation | en 25
2012.11 | 08 | 4998122704