Disassembly; Lcd Panel; Invertor Trans Unit) - Sony DCR-TRV8 Service Manual

The following flow chart shows the disassembly procedure.
2-2. Front panel assembly
2-3. Cabinet (L), BT panel assembly
2-4.EVF
2-6. DD-123 board, VC-217 board
2-7. Mechanism deck
2-8. CS flame assembly
2-9.Lens, Outer connector (hot shoe), JK-170 board
NOTE: Follow the disassembly procedure in the numerical order given.
2-1. LCD PANEL (PD-110 BOARD, INVERTOR TRANS UNIT)
3 P cabinet (M) assembly
(Remove the four claws A and B .)
Claws A
8 Indication LCD block
assembly (LCD901)
9 Cold cathode
fluorescent tube
(ND901)
SECTION 2

DISASSEMBLY

DCR-TRV8/8E/10/10E
!• FP-90 flexible board
!¶ Tapping screw
(M1.7 3.5)
!™ Screw
(M1.7
2 Two screws
(M1.7) lock ace
Claws D
Claws E
C
DCR-TRV8/TRV8E/TRV10/TRV10E
2-1. LCD panel (PD-110 board, invertor trans unit)
2-11. CK-84 board, Speaker
2-12. LCD, Control swith block
2-10.MS shassis, Control switch block (PS-4550)
5 FP-90 flexible board
CN8613 6P (PD-110 board)
!∞ Connector
(CN5802)
!¢ Connector
(CN5803)
2.5)
Claws B
4 P cabinet (C) assembly
2-1
2-5.LB-60 board
!£ PD-110 board
(Remove the two claws D and E .)
6 Flexible board (LCD901)
CN5601 24P (PD-110 board)
7 Flexible board (ND901)
CN5601 24P (PD-110 board)
!§ Inverter transformer unit
!¡ Crystal indication
module (LCD902)
(Remove the LCD after
releasing the claw from
the C area.)
!º Connector (CN5900)
1 Two screws (M1.7) lock ace