Modification Of E, F Page Data - Sony DCR-TRV8 Service Manual

Address Remark
66 Fixed data-1
67 (Initialized data)
68
69
6A
6B
6C
6D
6E
6F
70
71
72
73
74
75
76
77
78
79
7A
7B
7C
7D
7E
7F
80 to FF
Table. 5-1-4.
1-2-4. INITIALIZATION OF E, F PAGE DATA
1. Initializing the E, F Page Data
Note: If the E, F page data has been initialized, following adjustments
need to be performed again.

1) Modification of E, F page data

2) Camera system adjustments
Adjusting page
Adjusting Address
Adjusting page
Adjusting Address
Initializing Method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 6, address: 01, and set data: 2D (NTSC) or data:
2F (PAL) , and press the PAUSE button of the adjusting remote
commander.
3) Select page: 6, address: 03, set data: 01, and press the PAUSE
button of the adjusting remote commander.
4) Select page: 6, address: 02, and check that the data is "01".
5) Perform "Modification of F, E Page Data".
2. Modification of E, F Page Data
If the E, F page data has been initialized, change the data of the
"Fixed data-2" address shown in the following table by manual input.
Modifying Method:
1) Before changing the data, select page: 0, address: 01, and set
data: 01.
2) New data for changing are not shown in the tables because
they are different in destination. When changing the data, copy
the data built in the same model.
Note: If copy the data built in the different model, the camcorder may
not operate.
3) When changing the data, press the PAUSE button of the
adjustment remote commander each time when setting new
data to write the data in the non-volatile memory.
4) Check that the data of adjustment addresses is the initial value.
If not, change the data to the initial value.
Processing after Completing Modification of E, F Page data
1) Select page: 2, address: 00, and set data: 29.
2) Select page: 2, address: 01, and set data: 29, and press the
PAUSE button of the adjusting remote commander.
5-14
F
10 to FF
E
00 to 47