Step 2: Prepare For Express Setup; 2-1: Prepare Nec Express5800/Ft Series - NEC Express5800/320Fd-LR User Manual

4-8 Windows Setup

Step 2: Prepare for Express Setup

Before starting Express Setup, be sure to do the following. You can set up properly only when you
make those preparations.

2-1: Prepare NEC Express5800/ft series

With the power of NEC Express5800/ft series off, follow the steps below:
Prepare NEC Express5800/ft series.
1.
•
Mount the modules for both systems.
•
Mount only one hard disk to the Slot 1 of the CPU/IO module 0.
•
Remove all LAN cables.
•
Remove optional SCSI devices such as a tape device from the SCSI connector.
•
Remove cables from the connectors attached to the Fibre Channel board.
IMPORTANT:
Mount only one HDD to the designated slot of the designated CPU/IO module. If
multiple HDDs are mounted, the hard disk to install OS cannot be determined.
Prepare the installation from the CPU/IO module 0. Mount a HDD to the designated place
2.
when installing the OS.
The location of the parts required for operation and checking are shown below:
CPU/IO module 0
CPU/IO module 0
Power LED
CPU/IO module 0
Status LED
CPU/IO module 1
Power LED
CPU/IO module 1
Status LED
CPU/IO module 1
CPU/IO module 0
POWER switch
Front side of device
CPU/IO module 1
Power switch
Be sure to keep this
turned on.
Mount only one HDD here
when you install/reinstall OS.
CPU/IO module 0
DISK ACCSSS LED
CPU/IO module 1
DISK ACCESS LED