At^ssync Configure Sync Pin - Siemens MC55 Command Set

MC55 AT Command Set
17.6 AT^SSYNC
17.6

AT^SSYNC Configure SYNC Pin

The command serves to configure the SYNC pin of the application interface. Please note that the
AT^SSYNC
SYNC pin may be assigned different functions: Depending on the design of the host application, the pin can
either be used to indicate the current consumption in a transmit burst or to drive a status LED connected to the
pin as specified in [2]. For detailed information on the SYNC pin and its LED functionality refer to [2]. Before
changing the mode of the SYNC pin, carefully read the technical specifications.
Syntax
Test Command
AT^SSYNC=?
Response(s)
^SSYNC: list of supported
OK
Read Command
AT^SSYNC?
Response(s)
^SSYNC:<mode>
OK
Write Command
AT^SSYNC=<mode>
Response(s)
OK
PIN ASC0 ASC1 MUX1
! % %
Reference(s)
SIEMENS
Parameter Description
(num)
<mode>
[0]
MC55_ATC_V01.05
Confidential / Released
s
<mode>
MUX2 MUX3
% % %
SYNC mode:
Enables the SYNC pin to indicate growing power consumption during a trans-
mit burst. You can make use of the signal generated by the SYNC pin, if power
consumption is your concern. To do so, ensure that your application is capable
Page 437 of 469
s
m
obile
2/10/04