Hdd Troubleshooting; Procedure 1 Partition Check; Procedure 2 Diagnostic Test Program Execution Check; Procedure 1 - Toshiba Qosmio X500 Maintenance Manual

2 Troubleshooting Procedures

2.6 2.5" HDD Troubleshooting

To check if 2.5" HDD is malfunctioning or not, follow the troubleshooting procedures below
as instructed.
Procedure 1: Partition Check
Procedure 2: Message Check
Procedure 3: Format Check
Procedure 4: Diagnostic Test Program Execution Check
Procedure 5: Connector Check and Replacement Check
CAUTION: The contents of the hard disk will be erased when the 2.5" HDD
troubleshooting procedures are executed. Transfer the contents of the hard
disk to other storage drive(s). For the backup, refer to the User's Manual.

Procedure 1

Partition Check
Insert the Toshiba Free-DOS system disk and start the computer. Perform the following
checks:
Input C: and press Enter. If you cannot change to drive C, go to Check 2. If you
Check 1
can change to drive C, go to Procedure 2.
Check 2 Input FDISK and press Enter. Choose Display Partition Information from the
FDISK menu. If drive C is listed in the Display Partition Information, go to Check
3. If drive C is not listed, return to the FDISK menu and choose the option to
create a DOS partition or a logical DOS drive on drive C. If the problem still
occurs, go to Procedure 2.
Check 3 If drive C is listed as active in the FDISK menu, go to Check 4. If drive C is not
listed as active, return to the FDISK menu and choose the option to set the active
partition for drive C. Then go to Procedure 2.
Check 4 Remove the system disk from the FDD and reboot the computer. If the problem
still occurs, go to Procedure 2. Otherwise, the 2.5" HDD is operating normally.
Qosmio X500 Maintenance Manual (960-Q08)
19