Spectrum Display; L/R Select - Yamaha DME64N Owner's Manual

Spectrum Display

The monitor functions also provide spectrum analyzer type
level display of the signal at the selected monitor point.
NOT E
Spectrum display is not available on the ICP1 control panel.
Procedure
1.
Select the monitor point for which you want to
see a spectrum display from the list.
2.
Press the [ENTER] button.
A spectrum display of the audio signal at the selected
monitor point will appear.
1 4
1 Frequency
These are the separate frequency bands displayed.
2 Band Output Level
Signal level is displayed independently in 31 separate
frequency bands. Output level is displayed in 12 steps.
3 Peak Hold
When the peak hold function is ON, peak levels since the
current monitor point was selected are held indefinitely.
Peak levels are cleared after one second when peak hold is
OFF.
To turn the peak hold function ON or OFF, move the
cursor to the PEAK HOLD ON/OFF setting and press the
[ENTER] key to alternately turn it ON or OFF.

4 L/R Select

Indicates when the spectrum display is for the left or right
channel. The same spectrum display will be shown for the
L and R channels of all monitor points other than user-
defined points specified via the DME Designer
application.
To switch between the L and R displays move the cursor to
the CHANNEL L/R setting and press the [ENTER] key
to alternately select L or R.
N OTE
The fall rate of the meters can be set up via the Utility display
"Disp" page.
3
2
Spectrum Display
DME64N/24N Owner's Manual
45