Cp4Sw, Cp4Sf, And Cp1Sf - Yamaha DME64N Owner's Manual

CP4SW, CP4SF, and CP1SF

These controllers connect to the DME64N/24N via its GPI interface. These controllers only control the
DME64N/24N unit to which they are directly connected.
The CP4SW is a four-switch unit with four indicator LEDs, while the CP1SF and CP4SF have one and four
faders, switches, and LEDs, respectively. The parameters to be controlled by the switches and faders on these
controllers can be specified via the DME Designer.
CP4SW
LED
LED
Switch
Installation
Please have the CP4SW, CP1SF, and/or CP4SF installed by a Yamaha-qualified contractor. Consult your
Yamaha representative.
Cable
Cable lengths up to 100 meters can be used to connect to the DME64N/24N if CPEV cable with a conductor
diameter of greater than 0.65 millimeters is used.
Bare cable ends to be connected to the Euroblock as shown in the diagram.
Be sure to use shielded cable.
CAUTION
Do not tin (plate with solder) the exposed sections of the cable.
WARNING
N OT E
Refer to "Euroblock Connection" on page 35 for instructions on connecting cables to the Euroblock connectors.
CP4SF
LED
CONTROL PANEL
CP4SW
Single conductor. Twisted pair.
7mm
Fader
10 10 10 10
0 0 0 0
CONTROL PANEL
CP4SF
Switch
Shielded cable.
DME64N/24N Owner's Manual
CP1SF
10
LED
LED
0
CONTROL PANEL
CP1SF
Switch
Fader
7mm
Options
59