Datanet Fiber Optic Connections - Siemens 2000592-001 User Manual

DataNET Fiber Optic Connections

Description
Required Parts
Electrical/Mechanical
Description
16 • Installation
The Fiber Optic Coupler is mounted in a threaded, potted, gas tight fitting
assembly designed for use in hazadrous areas when properly installed in
a approved enclosure. Two Fiber Optic Couplers are required, one for
DataNET Channel A and one for DataNET Channel B. The couplers are
mounted through pre-drilled holes located in the top or side of the wiring
acess plates or safety box.
All mounting hardware is supplied with the DataNET Fiber Optic parts kit.
These parts are also available as spares and can be ordered from us.
Description
Fiber Optic Coupler Assembly
Fiber Optics Coupler Seal Nut
Fiber Optic Coupler Cable
The DataNET Fiber Optic Coupler performs translation of signals
between a DataNET Hub and Advance Maxum. The Fiber Optic Coupler
converts between electrical signals and optical signals. The conversion is
transparent to the network. Fiber Optic signals are impervious to
distubances caused by electrical interference from nearby equipment,
ground loops, power surges, or nearby lightning strikes.
DataNET Fiber Optics Couplers can drive up to 5000 feet of fiber optic
cable.
Part Number
2015828-001
N8005
2020947-0011
2000592-001