Fujitsu Eternus web GUI User Manual page 274

Chapter 9 Connectivity Management
9.1 Connectivity Status
• Reset Scope
The reset scope of the target port is displayed.
Reset scope is the range where the command reset request from the server is performed,
when the target port is connected to multiple servers. A "-" (hyphen) is displayed when the
port mode is "RA".
-
-
• Release Reservation if Chip is Reset
When you enable the function to release the volume's reserved status when the target port
(chip) is reset, "Enable" is displayed. If you disable the function, "Disable" is displayed.
A "-" (hyphen) is displayed when the port mode is "RA".
• iSCSI Name
The iSCSI name of the target port is displayed.
• Alias Name
The alias name of the target port is displayed.
If the alias name is not specified, the field is blank.
• Bandwidth Limit
The bandwidth limit of the target port is displayed.
This item is displayed when the WAN bandwidth that can be used for REC is designated.
A "-" (hyphen) is displayed when the type is "1G iSCSI" or "10G iSCSI".
• MTU
The MTU size of the target port is displayed.
"Maximum Transmission Unit (MTU)" is the maximum amount of data that can be transmitted
at the one time over the communication network.
A "-" (hyphen) is displayed when the port mode is "CA".
• CHAP
When CHAP authentication for the target port is enabled, "ON" is displayed. If the
authentication is disabled, "OFF" is displayed.
I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset
request.
T_L (T: Target, L: LUN)
Reset (cancels) the command request from all of the servers that are connected to the
port.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
274
P2X0-1090-02ENZ0