Chapter 4 Setup
>
4.3 ETERNUS DX60/DX80 Setup
4.3.5
Port Parameters Setup
Set the connecting information for the host port of the ETERNUS DX60/DX80 to connect to the
server.
Setting screens will vary depending on the ETERNUS DX60/DX80 model.
For setting-related details, refer to the "ETERNUS DX60/DX80 Web GUI User Guide". Also refer
to the "ETERNUS Disk storage systems Server Connection Guide" as required.
Refer
For Fibre Channel
On the [Set FC Port Parameters] screen, set the information for the connection (detailed Fibre
Channel port information) between the ETERNUS DX60/DX80 Fibre Channel port and the
server.
Procedure
1
2
P3AM-3042-03ENZ0
ETERNUS DX60/DX80 Disk storage system User Guide
This section explains the procedure for the setup using GUI. For the setup
using the CLI commands, refer to "ETERNUS DX60/DX80 Command Line
Interface (CLI) User's Guide".
"ETERNUS DX60/DX80 Web GUI User Guide"
"ETERNUS Disk storage systems Server Connection Guide (Fibre Channel)"
"ETERNUS Disk storage systems Server Connection Guide (iSCSI)"
"ETERNUS Disk storage systems Server Connection Guide (SAS)"
In the GUI screen, click [Set FC Port Parameters] under the [Host I/F
Management] menu on the [Global Settings] tab.
The [Set FC Port Parameters] screen appears.
Select a port and specify the necessary items in "Port Settings", and click the
[Set] button.
•
Connection
Select "FC-AL" or "Fabric".
Select "Fabric" when using the Fibre Channel switch connection.
•
Set Loop ID
Select "Manual" if "Connection" has been set to "FC-AL".
•
Loop ID
Enter the Loop ID if "Connection" has been set to "FC-AL".
•
Transfer Rate
Select the fixed transfer rate according to the destination server or Fibre Channel
switch.
-
For the ETERNUS DX60
Select from 4Gbps, 2Gbps, or 1Gbps
-
For the ETERNUS DX80
Select from 8Gbps, 4Gbps, or 2Gbps
133
Copyright 2009 FUJITSU LIMITED