Hitachi XP P9500 User Manual page 558

Message ID
KAPL10937-W The maximum number of paths
KAPL10938-I
KAPL10939-W An error occurred during
KAPL10940-W The maximum wait time has
8-98
Message Text
was exceeded. Revise the
configuration so that the
number of paths is less than, or
the same as, the maximum
number. Refer to the Messages
section of the HDLM User's
Guide for instructions to correct
this problem.
dlmcfgmgr Log File Size(KB) :
aa...aa
processing to read a file. File
name = aa...aa
been reached. Maximum wait
time = aa...aa, Checking
interval = bb...bb
Messages
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Explanation
Action
Execute the dlmcfgmgr utility
with the -logfs parameter
specified. If the error occurs
again, /etc/opt/
DynamicLinkManager/
hdlm_utillog.conf which is not a
regular file might exist. Delete /
etc/opt/DynamicLinkManager/
hdlm_utillog.conf and then
execute the dlmcfgmgr utility
again. For details on the
dlmcfgmgr utility, see
Utility for Managing the HDLM
Configuration on page
Details
The number of paths in the entire
system exceeded the maximum
number of paths supported in
HDLM. Review and, if necessary,
revise the configuration.
Action
The maximum number of paths
supported in HDLM has been
exceeded. Review and, if
necessary, revise the number of
paths in the entire system. For
details on the number of paths
supported in HDLM, see
of Paths Supported in HDLM on
page 3-66.
Details
aa...aa: The setup value or default
value of dlmcfgmgr Log File Size.
Action
None.
Details
An error occurred during
processing to read a file.
aa...aa: File name
Action
Follow the instructions in the
message that was output before
this message.
Details
The maximum wait time has been
reached.
aa...aa: Maximum wait time
bb...bb: Checking interval
dlmcfgmgr
7-22.
Number