HP Surestore 330fx - Optical Jukebox Manual page 13

5. Attach the power cables. Refer to Figure 10 for proper power cable connections.
a. Connect the interposer PCA power cable.
1. Connect the 2 connectors on the power cable to the lower interposer PCA (at the
upper and middle power connectors on the right side of the interposer PCA).
2. Route this cable to the new power supply along the path indicated in Figure 10.
Use the stake-in clamps along the path.
b. Connect the interposer PCA power cable connectors to the connectors on the top of the new
power supply as shown in the detail of Figure 10.
c. Attach the short AC power cable to the bottom of the new power supply and to the power
distributor PCA as shown in Figure 10.
3. Install the "old" SCSI interface PCA in the new interface module.
a. Mount the SCSI PCA you removed from the previous module into the new enclosure. Use
the 6, 1/4-inch hex standoff screws from the upgrade kit. See Figure 11.
b. Install the new SCSI PCA on top of the first PCA. Mount its screws into the hex standoffs.
Use the T-15 screws that were previously installed. Add a jumper to the left-most position
of the jumper block shown in Figure 12.
Figure 10: Paths for connection of power cables
13