HP Surestore 330fx - Optical Jukebox Manual page 11

((Place the interface module and interface board aside.))
4. Install the new, lower interposer PCA below the one currently in the jukebox.
Figure 6 shows the location of this PCA and Figure 7 shows how cables are routed from the upper
interposer PCA and the new, lower interposer PCA.
a. Attach the loose end of the new interposer-to-interface SCSI cable to the interposer PCA by
bringing the cable BEHIND the board up and over the top, connecting it on the top of the
board. Put the PCA in place against its screw mounts on the chassis.
Note
There are NO CABLES connected to the BOTTOM
connection of the new, lower interposer PCA.
b. Mount the PCA by inserting and tightening the 8 T-20 screws.
c. Attach the GPIO cable from the controller PCA to the top left of the lower interposer PCA.
Refer to Figure 8 for the location of this cable.
Figure 7: Correct placement of the interposer PCA
11