Loading An Original; Using The Rspf; Using The Document Glass - Sharp AR-FX7 Operation Manual

LOADING AN ORIGINAL

An original can be loaded in the RSPF or placed on the document glass. Load multi-page sheet originals in the
RSPF. Place books and other originals that cannot be loaded in the RSPF on the document glass.

USING THE RSPF

1
Lift the document cover/RSPF and
make sure an original is not placed on
the document glass. Gently close the
document cover/RSPF.
If originals are placed both in the RSPF and
Note
on the document glass, only the original in
the RSPF will be scanned.
2
Adjust the original guides on the
RSPF to the width of the original.

USING THE DOCUMENT GLASS

1
Open the document cover/RSPF,
place the original face down on the
document glass, and close the
document cover/RSPF.
10
3
Align the edges of the original pages
and then insert the pages face up in
the document feeder tray.
Regardless of the size of the original, place the original
in the far left corner of the document glass. (Align the
upper left-hand corner of the original with the tip of the
mark.)
Document glass scale
A5
B4
A4 A3
Insert the stack into the
document feeder tray
until it stops. The stack
should not be higher than
the indicator line
(maximum 100 pages).
Document glass scale
A4R