Chapter 2
Before you install the hot-swap disk drive modules, decide where to place them in
the secondary mass storage cage. Figure 2-11 shows the drive blockers, which
prevent installation of drive modules into unsupported positions.
Drive Blockers
prevent installation
of drive modules into
unsupported positions
Figure 2-11. Drive Blockers in Hot-Swap Mass Storage Cage
NOTE
SCSI addresses (IDs) in the secondary hot-swap mass storage
cage are different from and independent of SCSI addresses in
the primary cage. SCSI addresses for devices in both cages for
single-bus and dual-bus configurations are shown in your
HP NetServer installation guide and the HP NetServer Duplex
Kit Installation Guide.
Installation
21