HP D7171A - NetServer - LPr Configuration Manual page 26

Connecting the Cluster's Shared Storage
Refer to one of the following schematics as you connect the HP Storage System/6 cabinet(s) to the cluster's
NetServers. Use only D5957A NetRAID Cluster Adapters to connect the HP Storage System/6 to the servers.
To connect the HP Storage System/6 unit(s) to the HP NetServers:
1. Power down all cluster hardware including both HP NetServers and the HP Storage System/6 cabinet(s)
2. Install the hot swap disks in the HP Storage System/6 cabinet(s).
NOTE If you are using two HP Storage System/6 cabinets, proceed to steps 5 and 6 where you add cluster
adapters for channel 1. Otherwise, proceed to "Connecting the LAN Adapters.".
3. Connect System A's NetRAID channel 0 to the SCSI A port located on the back of HP Storage
System/6 #0.
4. Connect System B's NetRAID channel 0 to the SCSI B port located on the back of HP Storage
System/6 #0.
System A
SCSI-B
SYSTEM
DISK
NetRAID
Ch0
HP NetServer LH Pro Cluster with One HP Storage System/6
5. Connect System A's NetRAID channel 1 to the SCSI A port located on the back of HP Storage
System/6 #1.
6. Connect System B's NetRAID channel 1 to the SCSI B port located on the back of HP Storage
System/6 #1.
HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997
Part 5: Installing HP NetRAID Software and Configuring the Disk Arrays
SCSI-A
External
CD-ROM
Ch1
A
#0
SCSI-B
SYSTEM
DISK
SS/6
B
System B
SCSI-A
CD-ROM
NetRAID
Ch0 Ch1
17