HP D5970A - NetServer - LCII Installation Manual page 13

Chapter 1
Add Boards
Add Processors
Replace Top Cover
Setting Up the HP NetServer LPr
BE SURE to remove handles from PCI cards.
Note that there are specific subsections in
Chapter 7 dealing with installation of the HP
NetRAID and Remote Control cards on the PCI
bus.
See the readme file on HP NetServer Navigator
CD-ROM for recommended slots.
Note that slot assignments of disk drive controller
cards affects boot order.
For details see Chapter 7, "Installing Additional
Boards."
BE SURE processor modules are rated for the
same clock rate.
Add an additional Voltage Regulator Module
(VRM) as well as a processor module.
For details see Chapter 8, "Installing Additional
Processors."
Be sure cables are properly routed and all
components are fully seated.
For details see Chapter 3, "Opening and Closing
the HP NetServer LPr."
5