HP D5970A - NetServer - LCII Installation Manual page 122

Chapter 10
Select No for manual NOS installation.
Perform a manual NOS installation if you are installing a NOS other
than certain versions of Novell NetWare/IntranetWare or Microsoft
Windows NT Server, or if you have replaced any HP components.
For Manual NOS Installation Only: Before you perform a manual NOS
installation, you must print instructions and manually create
NOS-specific driver diskettes as follows:
Create Drivers Diskette(s): On the Create Drivers Diskette(s)
screen, select Create Drivers Diskette(s) to create one or more
customized diskettes containing HP drivers and configuration files
to use when you install the NOS.
Print and Read Instructions: On the Show NOS Installation
Instructions screen, select Save to Disk to copy the Network
Operating System Installation Instructions to disk. Then print them
out from the disk. Read the instructions first, and then follow them
to manually install the NOS.
View Configuration Advisories:
Read the configuration advisories and print them if necessary. You can
change your hardware at this time to conform to the advisories.
Configure Remote Management:
This utility configures the Integrated Remote Management device for
remote management. It enables remote, dial-up HP NetServer
management.
To configure Integrated Remote Assistant, select Configure Remote
Management on the Configure Remote Management screen.
Show System Information:
Use this screen to display information about standard and accessory boards
and devices in the system, as well as the used and available system
resources.
Select View Hardware Inventory on the Show System Information
screen to display information about standard and accessory boards and
devices in the system.
Select View Resources on the Show System Information screen to
display used and available system resources such as memory ranges,
I/O port ranges, DMA channels, and interrupt (IRQ) levels.
114
Configuring the HP NetServer