HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 100

5. Push the drive into the selected bay until it snaps into place (1), as shown:
Figure 4-46
6. Attach the power (2) and data (3) cables to the SAS drive, and then insert the SAS controller card
into an available PCI slot in the workstation chassis.
7. As shown in the following figure, connect the data cable from the hard drive to the controller card.
Figure 4-47
8. If necessary, install the SAS card in an empty PCI Express slot, and then install the LED cable from
the card to the system board. You can find the location of this connector on the service label on
the inside of the side access panel.
To install three or four SAS drives, install the third and fourth drives in the workstation optical drive bays.
For instructions, see
90 Chapter 4 Removal and replacement procedures
Installing the SAS hard drive
Connecting the SAS cable to SAS hard drive
Installing SATA hard drives in an optical drive bay (optional) on page 94.
ENWW