Assembling The Clavinova - Yamaha Clavinova CLP-480 Owner's Manual

Assembling the Clavinova

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the
sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Assemble the unit on a hard and flat floor with ample space.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Philips-head (+) screwdriver of the appropriate size ready.
Remove all parts from the package and make sure you have all of the items.
Connector
panel
Pedal cord
The pedals are covered with vinyl covers when
shipped from the factory. For optimum use of the
GP Responsive Damper Pedal, we recommend
that you remove the cover from the damper pedal.
E
Appendix
82
Assembling the Clavinova
A
AC IN
Foamed styrol pads
Take out the styrofoam pads, and place A on top of the pads.
Position the styrofoam pads so that they do not interfere with
B
the connector panel at the bottom of A, AC IN, or the fittings on
the center of the rear panel.
C
D
F
6 x 20 mm long screws x 4
6 x 16 mm short screws x 6
4 x 14 mm thin screws x 9
4 x 10 mm thin screws x 2
4 x 20 mm
tapping screws x 4
Cord holders x 2
Power cord
Headphone hanger