Yamaha Clavinova CLP-480 Owner's Manual page 38

2-3
Press the D [–][+] buttons to specify how the recording should
start and end.
Starting methods:
• Normal:
The existing data will be erased after re-recording starts.
• FirstKeyOn:
Data that exists prior to the point where you start playing a note will remain.
Ending methods:
• Replace:
The data after the point you stop recording will also be erased.
• PunchOut:
The data after the point you stop recording will remain.
3.
Press the [SONG SELECT] button to return to the song
selection display.
4.
Specify the start point you wish to re-record.
Use the B [– (NO)][+ (YES)] buttons to move the Song measure, or press the
[PLAY/PAUSE] button to start playback then press the [PLAY/PAUSE] button
again slightly prior to the desired point.
5.
If necessary, select the settings (Voice and other parameters).
Select the desired settings, if you wish to change the previous ones.
6.
Call up the Record mode.
When you specify the recording part:
Follow step 2 on page 36.
When you do not specify the recording part:
Press the [REC] button.
7.
Play the keyboard or press the [PLAY/PAUSE] button to
start recording.
8.
Press the [STOP] button to stop recording.
9.
Press the B [+ (YES)] to overwrite your performance.
To cancel the Overwrite operation, press the B [– (NO)] button.
10.
Press the [PLAY/PAUSE] button to play back the recorded
Song.
11.
Press the [EXIT] button to exit from the Record mode.
Advanced Functions
38
Recording your performance
MEMORY Bar 012
M _ 001 : NewSong001
NOTE
The Song Balance will not be
recorded.
NOTE
The time signature cannot be
changed when replacing the
part of an existing Song.