Radio Configuration From The Cli; Radio Configuration Using Snmp - D-Link DWL-3600AP Administrator's Manual

Unified Access Point Administrator's Guide
Radio Configuration from the CLI
1. Connect to the AP by using Telnet, SSH, or a serial connection.
2. Turn Radio 2 on if the status is not currently up.
set radio wlan1 status on
3. Set the mode to IEEE 802.11b/g/n.
set radio wlan1 mode bg‐n
4. Set the channel to 6.
set radio wlan1 channel‐policy static
set radio wlan1 static‐channel 6
5. Set the channel bandwidth to 40 MHz.
set radio wlan1 n‐bandwidth 40
6. Allow a maximum of 100 stations to connect to the AP at a time.
set bss wlan1bssvap0 max‐stations 100
7. Set the transmit power to 75 percent.
set radio wlan1 tx‐power 75
8. View information about the radio settings.
get radio wlan1 detail
Radio Configuration Using SNMP
1. Load the DLINK‐WLAN‐ACCESS‐POINT‐MIB module.
2. From the MIB tree, navigate to the objects in the apRadio table (apRadioBss > apRadioTable).
3. Use the apRadioStatus object to set the status of Radio 2 to up (1).
4. Use the apRadioMode object to set the Radio 2 mode to IEEE 802.11b/g/n, which is bg‐n (4).
5. Use the apRadioChannelPolicy object to set the channel policy to static (1), which disables the automatic
channel assignment.
6. Use the apRadioStaticChannel object to set the channel to 6.
7. Use the apRadioChannelBandwith object to set the channel bandwidth for Radio 2 to forty‐MHz (2).
8. Use the apRadioTxPower object to set the transmission power on Radio 2 to 75.
9. Navigate to the objects in the apBssTable.
10. Use the apBssMaxStations object to set the value of the maximum allowed stations to 100.
D-Link
November 2011
Configuring Radio Settings
Unified Access Point Administrator's Guide
Page 168