Unified Access Point Administrator's Guide
Client QoS Status
The Client QoS Status page shows the client QoS settings that are applied to each client currently associated
with the AP.
To view QoS settings for an associated client, click the Client QoS Status tab.
Field
Station
Global QoS Mode
Client QoS Mode
Bandwidth Limit Up
Bandwidth Limit Down Shows the maximum allowed transmission rate from the AP to the client in bits per
ACL Type Up
D-Link
November 2011
Figure 44: Client QoS Status
Table 56: Client QoS Status
Description
The Station menu contains the MAC address of each client currently associated with
the AP. To view the QoS settings applied to a client, select its MAC address from the
list.
Shows the current Client QoS Global Admin Mode on the AP.
Shows whether the QOS mode for the selected client is enabled or disabled.
Note: For the Qos Mode to be enabled on a client, it must be globally enabled on
the AP and enabled on the VAP the client is associated with. Use the VAP QoS
Parameters page to enable the QoS Global Admin mode and the per‐VAP QoS
Mode.
Shows the maximum allowed transmission rate from the client to the AP in bits per
second (bps). The valid range is 0 – 4 294967295 bps.
second (bps). The valid range is 0 – 4 294967295 bps.
Shows the type of ACL that is applied to traffic in the inbound (client‐to‐AP)
direction, which can be one of the following:
• IPv4: The ACL examines IPv4 packets for matches to ACL rules.
• IPv6: The ACL examines IPv6 packets for matches to ACL rules.
• MAC: The ACL examines layer 2 frames for matches to ACL rules.
Client QoS Status
Unified Access Point Administrator's Guide
Page 146