D-Link DSN-5410-10 - xStack Storage Area Network Array Hard Drive Software Manual page 107

Advanced Setting
Default Block Size
Alert Notification Setting
Email Notification Enabled
Email To Address
Email From Address
Email Server IP Address
Email Server Port
SNMP Traps Enabled
SNMP Trap destination IP address
SNMP Trap destination IP port number
SNMP Trap "Community" string
The following system failure conditions will generate an E-mail notification message and/or
an SNMP Trap, if those notification items are enabled. For more detailed information,
please refer to the Hardware Reference Guide for your storage array.
Failure Condition
Drive Failure
Power Supply Failure
Cooling Fan Failure
Battery Failure
Over Temperature
Software Failure
xStack Storage Management Center Software User's Guide
Specifies the default block size that should be used for all newly created volumes.
Choices are:
512 bytes (default)

4096 bytes (allows volume sizes up to 16TB with 32-bit operating systems)

Table 6-5. Alert Notification Settings
Indicates whether the storage system will send an alert notification by email when
an event occurs. Choices are:
Enabled = send an email alert. If you select this setting, the following four

fields must also be completed.
Disabled = will not send an email alert. (default)

Enter the email address where notifications are to be sent. This can be an
individual email address or an alias e-mail address for a distribution list.
Enter an IP address, email address, or other meaningful entry that identifies the
storage system as the source of the email.
Enter the IP address of the mail server through which email notifications from the
storage system will be routed. Default is 0.0.0.0.
Enter the SMTP port on which the mail server will be listening for email alerts
from the storage system. Default is 25.
Indicates whether SNMP Traps are enabled. Choices are
Enabled = SNMP Traps are enabled

Disabled = SNMP Traps are not enabled. (default)

Enter the IP address of the SNMP Trap destination. Default is 0.0.0.0.
Enter the port number of the SNMP Trap destination. Default is 162.
Enter the community string for the SNMP Trap destination.
Table 6-6. Alert Notification Conditions
Description and Additional Information
The Drive Fault LED will be illuminated, but there will be no audible alarm.
The System Fault LED will be illuminated, and the audible alarm will sound. Use the "Mute Alarm"
button to silence the audible alarm.
The System Fault LED will be illuminated, and the audible alarm will sound. Use the "Mute Alarm"
button to silence the audible alarm.
The System Fault LED will be illuminated, and the audible alarm will sound. Use the "Mute Alarm"
button to silence the audible alarm. A system restart is required after the battery has been replaced.
The System Fault LED will be illuminated, and the audible alarm will sound. Use the "Mute Alarm"
button to silence the audible alarm.
The System Fault LED will be illuminated, and the audible alarm will sound. Use the "Mute Alarm"
button to silence the audible alarm. The system will restart automatically.
Description
Description
97